The correct and timely care for our own garden is the key to the gullible and picturesque appearance of your possessions. But it often happens that due to the lack of time, the inexperience of the owner or under the influence of external environmental factors, the trees begin to bend and deformed. Naturally, such a process will pernicably affect the health of the plant, its fruitiness, as well as the pretty landscape. About how it is to cope with such a problem and quickly restore the health of trees, you will read in this article.

Why does the tree begins to lean?

As already mentioned above, there are several factors that cause this phenomenon.

Note the most common causes of this problem:

• damage to the root system with rodents, because of which the tree trunk begins to roll, as there is no solid foundation for him;
• failure to comply with the rules for planting a tree into the soil, namely, the introduction of a seedling into the ground is not strictly vertically, but with a certain inclination, which over the years is gradually increasing;
• constant influence of strong gusty winds;
• the late collection of fruits, as a result of which the branches are absorbed and leaked, especially with the intensive fertility of the plant;
• the accumulation of a large number of wet snow on the branches that fell on the eve also can provoke a sharp roll of wood.

Important! With a strong curvature of the tree, the roots from the opposite side are significantly turned outwardly, that even with not highly low temperatures may affect the frostbite and drying the root.

Consequences of inclined wood

Curves trees on residential territory can entail a lot of trouble, namely:

• create an emergency situation;
• become a threat to human health and life;
• apply a significant damage to property, if such a tree is near the construction;
• reducing the overall attractiveness of the landscape zone;
• in case of fall, damage to engineering lines is possible, which will reduce the comfortable operation of the house and causes the need for additional expenses.

Important! Please note that the timely identification of the problem contributes not only to the complete restoration of the plant, in which a straight tree develops on the site further, and avoids its removal and all the associated hassle. Given the rules of current legislation, solve the problem of the need for wood spill, even on its own site, you can not always quickly.

When is it better to do the alignment of the tree?

To solve the problem of the growing tree curve, come immediately if it rushes a threat to the next time. If the situation did not acquire an acute character, then late autumn is considered the perfect period for aligning such a tree.

Important! To independently understand how big the problem is, view the photo of the tree trunk of a different angle of tilt and the comments attached to them in the degree of unreliability. Compare seen with the features of the development of your plant.

Tree leveling rules

The tree equalization procedure is not so complicated, but for an effective result it will be necessary to pay a certain time and take care.

Sequentially and clearly follow these steps to align the growing tree curve:

1. With a small shovel, carefully remove the layer of the Earth 1-2 cm around the tree trunk.
2. Unscreakly pour the rolling-binding water to the water soil soil and roots become more movable.
3. Choose a suitable place under the column on the side opposite to the bending of the tree.
4. Discovered and hammer a post at a depth of 0.6-0.8 meters with a slope in the opposite direction relative to the tilt of the tree trunk.
   Important! The height of the knocked pillars should be slightly lower than the tree itself.
5. As a support pillar, use a massive wooden bar or metal pipe.
   Important! Do not try to straighten the curve from the first time. Do it in 2-3 stages with an interval of a few weeks, so that the roots do not damage and manage to go beyond the tree.
6. For stretching, use a wire, a soft braid or a clothesline, which tightly tie into one end around the tree trunk, and the other end is around the pillar.
7. To preliminarize the rope with a tree a lining from a thick foam, rubber, rolled by a few times the linoleum. This will prevent rubbing and damage to the bark.
8. In the process of folding the tree every 2 weeks, track so that the rope does not slip.
9. A month later, adjust the slope of the tree, by pulling up the rope to the post.

Important! If the wood dimensions are significant, you will not be able to perform the actions to equalize the tree yourself. In this case, attract the process of relatives or neighbors in the country area.

Prevention of tilt of trees

To avoid such a problem with green plantings on its own site and save your time to care for them, it is imperative in the process of growing trees, follow some of the recommendations of the roll prevention:

• regularly monitor the growth of plants in the correct vertical direction;
• immediately landing seedlings Do not be lazy to insert the pegs;
• take measures to eliminate rodents on the territory of your site;
• watch out for the level of soil flushing with heavy precipitation to eliminate damage to the root system or germination of its processes outside.

Video

Review the video instructions for performing the tree leveling procedure to more clearly imagine the task.

Conclusion

Be sure to follow the state of your trees and plants, then the landscape of your local area will look harmoniously, and the harmonious harmony will certainly please you with abundance of high-quality fruits.